Cleansol Chlorine Tablets · SDIC · Since 2002
The right dose kills germs.1 tablet for every 500 litres.
Chlorine disinfects only when each litre gets enough of it. Every Cleansol 5 g tablet is dosed for 500 L of tank water – so your overhead tank or sump gets full-strength disinfection, not a watered-down one.
= full-strength
disinfection
full-strength dose

Sound familiar?
Smell in your tap water? It starts in your tank.
Water that sits in an overhead tank or sump grows bacteria, algae and slime – especially in summer and monsoon. You notice it first as a bad smell, every time you use the tap.





Here's why
Clean outside. Not inside.
Your tank looks fine from the roof – but inside, stored water slowly turns into a home for germs. Algae and slime coat the walls, sludge settles at the bottom, and the water picks up a musty smell and a yellow-green tint.

Seen this in your bucket?Cloudy, yellow-green water with floating specks is a sign your tank needs cleaning and disinfection.
Prevention, not cleaning
Goodbye to frequent tank cleaning
Algae, slime and smell grow when stored water has no chlorine left in it. A tablet at every refill keeps a small, safe amount of chlorine in your tank all the time – so germs and green growth never get a chance to start.
Tank already green or full of sludge? Clean it once – then a tablet at every refill keeps it that way.
Why the dose matters most
Disinfection depends on the dose ratio – not on how many litres a tablet "claims"
Germs die only when the chlorine in every litre is strong enough. Put the same tablet in more water and each litre gets less chlorine. That is why we tell you the full-strength ratio, not the biggest number.

Full strength – germs killed

Half strength – germs may survive

Quarter strength – too weak
WHO reference: bacteria, viruses and Giardia are killed when 5 mg/L of free chlorine is kept for 30 minutes. One lab-tested tablet (3,100 mg chlorine) in 500 L starts above that level – the same tablet in more water does not. The test tube shows the chlorine in every litre.
Your dose
Same ratio for every tank size
The ratio never changes – 5 g for every 500 L. Just match the tablets to the water in your tank.
| Water in tank | Tank disinfection (1 tablet : 500 L) | Only if drinking from the tap (milder) |
|---|---|---|
| 500 L | 1 × 5 g | 1 × 5 g – use for washing first * |
| 1,000 L | 1 × 10 g (or 2 × 5 g) | 1 × 5 g – use for washing first * |
| 2,000 L | 1 × 20 g | 1 × 5 g |
| 5,000 L | 2 × 20 g + 1 × 10 g | 3 × 5 g |
| 10,000 L | 5 × 20 g | 3 × 10 g |
* For tanks under 1,500 L even one 5 g tablet is stronger than drinking strength – use the water for washing and bathing first; drink only after a test reads 0.2–1 mg/L at the tap. Count the water in the tank, not the tank size.
Enter your tank size (or measure it) and get the exact tablets for disinfection and for drinking water.
How to use
4 simple steps to germ-free tank water
1Count the water actually in the tank, not the tank size.
2Drop in the full-strength dose from the chart. Wash hands after.
330minClose the lid. The tablet dissolves and kills germs.
4Each new fill of water gets a new tablet – that is what keeps the tank clean.
Watch
See how it works – in 40 seconds
The science, simply
Residual chlorine – the guard that stays in your water
When you add a tablet, part of the chlorine is used up straight away killing germs and reacting with dirt. What is left over is called residual (free) chlorine – and it is what keeps your water protected.
If chlorine is still left after 30 minutes, the germs present have been dealt with. No residual means the dose was too weak.
Residual chlorine guards the water as it sits in the tank and travels through the pipes – so germs, algae and smell can't come back.
For drinking, free chlorine at the tap should be 0.2–1 mg/L (BIS IS 10500). Below 0.2 = not protected; above 1 = strong taste – use for washing first.
- ≥ 0.5 mg/L free chlorine after at least 30 minutes contact – for effective disinfection
- ≥ 0.2 mg/L at the tap – minimum residual to keep water protected
- 5 mg/L – WHO health-based guideline value for free chlorine in drinking water
- WHO has evaluated sodium dichloroisocyanurate (NaDCC / SDIC) for disinfecting drinking water
The tank dose starts strong to kill germs; as it works, the level drops. For drinking straight from the tap, test first – 0.2–1 mg/L is ideal.
Safe to drink? Test, don't guess
For drinking and cooking we also recommend an RO/UV purifier and a one-time lab test of your source water.
Lab-verified strength
What's inside every 5 g tablet
Tested for chlorine content (Certificate of Analysis). Each tablet delivers more chlorine than we claim.
| Description | White, round, flat, bevelled-edge tablets |
| Average tablet weight | 8.0 g (NaDCC content 5 g) |
| Identification | ✓ Passes |
| Available chlorine | Claimed3,000 mg Obtained3,100 mg |
What buyers say
Trusted for home tanks and sumps
"Doesn't leave a lime residue as bleaching powder does. From the odour one can guess that it does its job of disinfecting the water quite effectively."
J P · 20 g pack · Verified purchase · Amazon.in"Quality product and easy to use. Value for money."
Dr. Shilpa Puthran · 5 g pack · Verified purchase · Amazon.in"Good, effective than others."
Sekar D · 10 g pack · Verified purchase · Amazon.in"Used in sump. Very nice, good."
Sivakumar · 5 g pack · Verified purchase · Amazon.inWhy tablets
Chlorine tablets vs bleaching powder
Both use chlorine – but tablets make the right dose easy, every time.
Guess with a spoon – too little or too much
Exact: 1 tablet for every 500 L
Leaves lime and sludge at the tank bottom
Dissolves fully – no sludge
Loses chlorine fast once the pack is opened
Stable tablets in a sealed jar
Dusty, strong smell, hard to store
No dust, no mixing – just drop in
Choose your size
Choose the right pack for your tank
5 g × 30 tabletsFor 500 L tanks1 tablet = 500 L · treats 15,000 L in all
10 g × 30 tabletsFor 1,000 L tanks1 tablet = 1,000 L · treats 30,000 L in all
20 g × 35 tabletsFor 2,000 L tanks & sumps1 tablet = 2,000 L · treats 70,000 L in all
Society, school, hotel or clinic?
Regular supply at factory price
Monthly tablets for big sumps and many tanks – GST invoice and pan-India delivery. Tell us your tank sizes and we'll work out the dose.

FAQ
Questions, answered
How many chlorine tablets for a 1,000 litre tank?
For tank disinfection, 1 × 10 g tablet (or 2 × 5 g). For drinking water use one 5 g tablet, use the water for washing first, and drink only once it tests 0.2–1 mg/L.
Why 1 tablet per 500 L and not 1,000 L?
That is the full-strength dose that gives enough chlorine to disinfect stored water. The same tablet in 1,000 L gives only half the chlorine.
How often should I add tablets?
At every refill – 1 tablet for every 500 L of fresh water added. Regular use keeps residual chlorine in the tank, so algae, slime and smell don't come back and you need to clean the tank far less often.
Can I mix it with other cleaning chemicals?
No. Use the tablets on their own – never mix with bleaching powder, acids or other cleaners.
Will I still need to clean my tank?
Far less often. A tablet at every refill stops algae, slime and smell from growing in the first place. If your tank is already green or full of sludge, clean it once – the tablets disinfect water but can't remove deposits already stuck to the walls.
Does it reduce TDS, hardness or iron?
No. Chlorine tablets kill germs and stop algae and smell. They do not change TDS or hardness, or remove rust, iron or chemicals – for drinking water use an RO/UV purifier as well.
My tablet weighs more than 5 g – why?
The "5 g" is the pure SDIC (the active disinfectant) in each tablet. The tablet itself weighs about 8 g, because it also contains binders that hold it together and help it dissolve evenly. Lab result: 3,100 mg available chlorine per tablet.
What is the shelf life?
24 months in the sealed jar. Keep the lid tightly closed and store in a cool, dry place away from sunlight and moisture.
How long should I wait before using the water?
Let the tablets dissolve fully, then wait at least 30 minutes.
Is the water safe to drink after treatment?
Use the milder drinking-water dose and check free chlorine at the tap (0.2–1 mg/L). For drinking we also recommend an RO/UV purifier and a lab test of your source water.
Can I use them in a swimming pool?
No – pools need pool-grade chlorine and a different dose. See our pool care range.
Safety: Handle with dry gloves. Never mix with acids, toilet cleaners or other chemicals. Store closed in a cool, dry place, away from children and moisture. Not for direct consumption.
